The multiple pin locking feature on the pump inlet allows for removal and repositioning without damage or loss of retention. This is a huge advantage over the "one use only" filter socks that are included with most pumps.

Features

The TI 450 LPH (F90000267), 400 LPH (F90000262) & GSS342 (and others with the 11mm O.D. inlet) plug directly into this HydraMat

The outlet has 6 positions to orient the HydraMat for best location in the fuel cell

The pin locking feature on the pump inlet allows for removal and repositioning without damage or loss of retention

Patent pending design that solves the problems associated with traditional fuel pick-ups in stock fuel tanks as well as racing fuel cells

Greatly reduces the potential for air to enter into the fuel system which can result in poor engine performance and/or engine stalling

Perfect for vehicles experiencing fuel starvation during hard cornering, acceleration, stopping, inclines, and low fuel conditions

Surface tension and fluid wicking allow the HydraMat to continue to draw fuel from the tank or cell even when part of the mat uncovered

As an area of the HydraMat is uncovered, tiny pores in the media seal off through surface tension, forcing fuel to be drawn from other areas of the mat where fuel continues to be available

Unique internal reservoir assists in keeping fuel available at the pickup even under extreme fuel slosh conditions

Eliminates the need for specialty reservoirs, sumps and pick up pumps saving cost and greatly reducing complexity

Also acts as a 15 micron pre-filter eliminating the need for a separate filter before the fuel pump

Replacement HydraMat for Retro-Fit fuel modules; 12-130, 12-131, 12-132 and 12-133

HydraMats are also available in other sizes and shapes to fit a variety of stock fuel tanks and/or race fuel cells