Note: If installing the Blaster SS Coil to a points distributor or a non-current limiting ignition system without an MSD Ignition, a 0.8 ohm ballast resistor is required (MSD PN 8214). The resistor should wire in series along with any factory resistors on the positive coil wire.

Features

Improved output coil for electronic ignitions, and MSD Ignitions

Efficient winding design and assembly creates a compact housing

Primary and secondary windings are encased in Ciba polyurethane

70:1 turns ratio and lower primary resistance produce high voltage output

Tough, rigid housing with a tall tower and brass primary terminals

CARB E.O. D-40-37