Holley set the bar in 2011 with the release of the HP and Dominator in-line fuel pumps. In 2015, Holley has raised the bar again with the introduction of the VR1 and VR2 Brushless in-line fuel pumps. Featuring brushless pump technology and a twin screw rotor design, the VR1 and VR2 in-line fuel pumps are capable of high pressures and flows while maintaining a low amperage draw and quiet performance. Designed to work on high boosted race cars as well as your daily driven weekend endurance car, these pumps work with gasoline, methanol, and E-85* and can maintain pressures of 130 PSI and up to 335 GPH flow**. Fueled by TI Automotive. The pumps include a 2 step controller for pump speed control. The pumps can be ran in one of two different speeds. A low speed control for low fuel consumption requirements or at full speed for high fuel consumption requirements. The VR2 includes (2) controllers for precise control of both pumps independently of each other. Both the VR1 and VR2 pumps are proven for 18.5V compatibility. **At 13.8V * Overall pump dimensions: 9.5" Long; 4.75" Wide; 2.75" Tall* Overall pump dimensions: 9.5" Long; 4.75" Wide; 2.75" Tall

Features

Capable of 130 PSI while providing significant flow forced induction applications where belt driven pumps are normally used.

Unlike other pumps, the VR Series are built for continuous duty if needed.

The dual pump models are designed for endurance racing where both pumps are used or one can be a reserve pump.

Billet aluminum construction for durability and good looks

Features a dual 10 AN O-ring inlet and a single 10 AN O-ring outlet

High flow and high pressure with low amperage draw

Can be fully submerged in the fuel cell or chassis mounted

Maximum amp draw of 38 AMPS for the VR2

Holley also offers a complete line of fuel filters and fuel pressure regulators that are designed to work as a system with these pumps